A leaking kit can turn a pleasant experience into a sticky, frustrating mess. Instead of enjoying a smooth session, you’re dealing with messy hands and wasted liquid. The good news is that most leaks are easy to fix with a few simple checks.
By focusing on a few key areas, you can keep your device clean and performing well. Below is a list of simple ways to solve the issue and keep your SMOK kits performing at their best.
Check your seals:
The small rubber rings, called O-rings, are vital for a tight seal. These can wear out, tear, or become misplaced over time. Take a moment to inspect the O-ring on the tank’s base and the one on the coil head. If you see any cracks or warping, replace them. Always ensure the O-ring is seated correctly after cleaning or changing a coil.
Screw everything together:
A loose connection is a common cause of leaks. Your tank needs to be firmly assembled, but be careful not to over-tighten. Gently screw the coil into the base, then attach the tank glass and top section. Finally, secure the full tank to the battery mod. Hand-tight is enough; using too much force can damage the threads and cause new problems.
Prime your coil correctly:
A dry coil needs time to absorb liquid before you use it. Add a few drops of liquid directly into the cotton wick holes on a new coil. After filling the tank, wait for five to ten minutes. This lets the cotton swell and fill any gaps. If you don’t prime the coil, the first heat can burn the dry cotton, creating holes where liquid can leak through.
Fill the tank the right way:
When you add liquid, ensure it goes into the main tank chamber and not the center tube. The center tube is for air flow. If liquid gets inside it, it will flood the coil and leak out of the air holes at the bottom. Tilt your tank slightly and aim the bottle tip against the glass to avoid this mistake.
Store it properly:
How and where you keep your device matters. Never leave a filled tank on its side for a long time, especially in a warm place like a car. Heat can thin the liquid and pressure can force it through seals. Always store your kit upright in a cool area. This simple habit prevents most passive leaks.